In the field of application of inspection well mould, from the actual use of the template, most inspection wells are mainly round inspection well mould, a small number of square inspection well mould, square inspection well mould are used in rainwater wells, so in the production of concrete inspection wells, circular is the main, square is the auxiliary. At the beginning of the manufacture of common concrete inspection wells, the moulds used block layers to upgrade, which not only wasted time and manpower, but also limited the quality and life of the blocks, which could not be compared with the overall concrete inspection wells, so this kind of block was gradually eliminated. Therefore, circular concrete inspection wells are taken as an example. According to the configuration standards of wellbore, wellbore and connecting holes, the inner diameter of wellbore is indicated one by one. Generally, the inner diameter of wellbore is 700 centimeters and the wall thickness is 8-15 centimeters, while the inner diameter of wellbore is more than 1 meter. There are several types of wellbore with inner diameter of 1 meter, 1.2 meters, 1.25 meters and 1.5 meters. The wall thickness and the size of connecting holes of these inspecting wells with different inner diameters are different, which are mainly closely connected with the construction pipeline.
The use of inspection well mould is to be processed and produced together with other matching mould. It can satisfy the precast production and cast-in-place production of the project. Reserved holes will also be left on both sides. Within this period of time, the production steps can be repeated for a long time. To meet the needs of different projects. There will not be too much wear and tear on the die. After the completion of production, the mould should be cleaned and maintained uniformly, and the whole mould of cement inspection well should be brushed with rust-proof oil for preservation. When inspecting the use of well moulds, there should be no deviation or even deformation during processing. If the moulds are rusty, they should be rusted in time after use, and brushed with protective agent to store them for a long time, so that they can be registered in the warehouse. Considering that the current inspection well mould can not be easily moved, so it can be erected at four corners of the factory building, the fan drives the flow of air, so that we can completely solidify after we can dismantle the mould.