The main structure of the prefabricated inspection well mold is according to the internal shape of the prefabricated parts of the inspection well, because the function of the prefabricated inspection well mold is not only the well body, but also the position of the connecting hole and the ladder hole. Each set of mold often matches the size of the corresponding pipe according to the size of the inner diameter. Prefabricate inspection well mould, cement inspection well mould and inspection well mould manufacturers have a variety of structure combinations, which can simply purify our sewage, block the impurities in our sewage, and also make our construction personnel convenient and fast for detection. So the prefabricated inspection well mold is assembled by many parts, which is not a simple production technology. Then the prefabricated inspection well mold is the first beginning of a good mold from the design drawings to the selection of materials, until the blanking for preparation and manufacturing. Therefore, when each customer makes a choice, he should pay more attention to a good enterprise. No We will reduce the cost again and again, but we will continue to invest in technological innovation and technological research and development. Only a more perfect steel mold can win the needs of different customers and requirements.
In the prefabricated inspection well mould, select the appropriate inner diameter for customization. Generally, the inner diameter of the rainwater inspection well mould is 100 * 100 or 136 * 136 cm. This kind of rainwater well is similar to the conventional one. The customization of each set of formwork is generally 1 m high. Among the numerous steel formworks, the prefabricated inspection well mold is large in appearance and volume, but it is hollow in the interior, so it is very simple to weld, but it involves the mold specification and size, and the production form is also different, generally smaller than the inner diameter of 60 cm, so it is necessary to select the overall draft, so it is convenient to produce the rainwater well, saving the steps of upper and lower screws. For the rainwater well mould with inner diameter more than 80 cm, block mode should be selected, because draft will affect the long-term use quality and efficiency of the mould. Manufacturers will produce their own molds according to the specific needs of customers