The inspection well mold is a kind of inspection well mold, and there are also rectangular inspection well mold, but it is not as widely used as the electric inspection well mold. The mold is divided into two parts: internal mold and external mold. The internal mold is divided into three parts and the external mold is divided into two parts. Before using the electric inspection well mold, each template must be spliced, and the joints of these bolts are connected by bolts Therefore, the splicing mode of the mold is very simple. It is only necessary to put the corresponding formwork together and fix it with bolts. Then, the circular part composed of the internal and external molds is brushed with release agent. Then, in order to make the prefabricated products stronger, the steel bars should be prepared together and put into the mold. In the next step, the cement, sand, etc. shall be mixed in accordance with the specification proportion and poured into the mold to be exposed to the sun. The setting time of the mud shall be determined according to the temperature and humidity of the day. The setting time shall not be too long to avoid too tight adhesion between the mold and the mud. When demoulding, it is necessary to find a worker to enter the internal mold and dismantle the internal mold first. Several workers are needed outside to assist the workers in the internal mold to dismantle the internal mold. When dismantling the bolts, use an electric wrench to screw down the bolts. First extract the small conical formwork in the internal mold, and then dismantle the other two pieces. After the internal mold is dismantled, dismantle the external mold.
The wide use of inspection well requires the standardization process of cement inspection well mold. The standardization of cement inspection well mold is very important for improving the quality of mold, shortening the mold making cycle, improving the production efficiency and reducing the manufacturing cost, It is to standardize and serialize the shapes and sizes of many parts that make up the mold, as well as various typical combinations and typical structures according to the unified structure forms and sizes, and organize specialized production to fully meet the user's selection, We can also design and process all kinds of cement inspection well mould and mechanical equipment according to your requirements