The height of power inspection well mold is generally between one meter and two meters. The specific data needs to be determined according to the engineering drawings. The processing method of steel mold is nothing more than grouting vibration waiting for air drying and demoulding. Our factory suggests looking for a factory close to the construction site to provide the corresponding site and equipment for the production of water storage well, so that the mold can be used reasonably It can produce qualified water storage wells to help the later construction. According to the different construction standards, there are many sizes of water storage wells that can be selected at will. According to the conventional requirements, the mold of drainage inspection well with a height of 1.5 meters and a diameter of about 3 meters is relatively common in the market. The whole set of mold is of double-layer structure. When using, the inner mold should be placed in the center of the outer mold without any deviation The gap between the layer molds after splicing is actually the thickness of the water storage well. Therefore, it is required to fix the mold before grouting. During the grouting process, the slurry should be poured along the gap, and the formwork should be removed quickly after the slurry solidifies.
The power inspection well mold needs the combination mold to complete the use, which means that the inspection well mold is divided into two parts for use, and the internal mold and the external mold cooperate to produce a standard water collecting well. The internal model is as like as two peas of three unequal sizes. Although the sizes are different, the strength and thickness of the steel plate are the same. The outer die is exactly the opposite of the internal die. Two pieces of the same steel plate are spliced together, and three different sizes of internal die are assembled together to facilitate the release of the slurry after solidification, so as to reduce the difficulty of the demolding die. The reason why the thick steel plate is used to make the mold of drainage inspection well is to make the mold with larger size smoothly, and in order to make the mold have higher production strength, the manufacturer will use thicker steel material as rib plate for cutting and welding on the basis of 4mm thick steel plate according to the scientific proportion, so as to strengthen the compression effect of the mold.